One of the most important pieces in your computer is the motherboard. It’s a complicated piece that controls all the other components and makes sure they’re working together properly. If you have a dirty motherboard, it can be challenging to get it clean again without ruining everything else around it.
In this blog post, we’ll cover how to clean a dirty motherboard with 11 steps, so you don’t have any problems!
How to Clean Dirty Motherboard :
Step One: Cleaner can be toxic, but this homemade alternative is safe for you and your computer! Heat an old toothbrush in boiling water Dip it into baking soda Dip brush back into hot water Squeeze out excess liquid Wipe off any dirt, grime, or dust Repeat until clean.
Step Two: Clean the bottom of your motherboard Heat an old toothbrush in boiling water Dip it into Epsom salts Dip brush back into hot water Squeeze out excess liquid Wipe off any dirt, grime, or dust Repeat until clean Allow to dry Remove case fan Clean between blades with a toothbrush Dip toothbrush in hot water Wipe off dirt, grime, and dust Blow out any debris that might still be inside!
Clean the heat sinks.
Use a can of compressed air to clean around fan blades. Turn on the computer for 15 minutes. This will help evaporate the cleaner. Any remaining cleaner should disappear by next morning. Make sure not to touch fans or blades after cleaning!
Clean the CPU
Use a can of compressed air to clean around fan blades. Turn on the computer for 15 minutes. This will help evaporate the cleaner. Any remaining cleaner should disappear by next morning. Make sure not to touch fans or blades after cleaning!
Clean the RAM
Use a can of compressed air to clean around fan blades. Turn on computer for 15 minutes. This will help evaporate the cleaner. Any remaining cleaner should disappear by next morning. Make sure not to touch fans or blades after cleaning!
Clean the motherboard.
Use a can of compressed air to clean around fan blades. Turn on the computer for 15 minutes. This will help evaporate the cleaner. Any remaining cleaner should disappear by next morning. Ensure not to touch fans or blades after cleaning Wipe down case interior with hot soapy water Wipe case exterior with old towel Rub dry cloth against any dirty spots.
If necessary, use a toothbrush dipped in soap and water to scrub stubborn areas. Rinse out cloth as needed. Repeat until all dirt is gone; Allow pieces time to fully dry before applying new thermal paste. Reassemble your computer. Once things have dried, apply a new thermal compound according to directions. You can find it at most electronic stores!
The cleaner can be toxic, but this homemade alternative is safe for you and your computer! Heat an old toothbrush in boiling water Dip it into baking soda Dip brush back into hot water Squeeze out excess liquid Wipe off any dirt, grime, or dust Repeat until clean.
Conclusion:
The last thing you want to do is make the problem worse by risking contamination or damaging sensitive components. Remember, before beginning any cleaning procedure, always turn off your computer and allow it to cool for at least 30 minutes. Next, disconnect all cables from the motherboard to avoid accidentally shocking yourself when touching exposed wires.
Finally, use a Q-tip dipped in alcohol (or distilled water) with an applied amount of gentle pressure on both sides of the board – but not too hard! Make sure that there are no spills or other substances anywhere near where you’ll be working so as not to risk spreading them further onto delicate circuits.
And voila! You’ve successfully cleaned your PC’s motherboard without making things worse for yourself.
